Isolation and cultivation of ACSA-2−positive astrocytes from neonatal mouse brain
This application protocol describes the generation of highly purified and viable astrocytes from neonatal mouse brain tissue. Brain tissue from mice younger than P8 is dissociated into single-cell suspensions and astrocytes are then isolated using the Anti-ACSA-2 MicroBead Kit. The ACSA-2 antigen is expressed specifically on astrocytes in a pattern similar to GLAST and serves as a specific marker for astrocytes in the central nervous system.1,2 The proportion of ACSA-2+ astrocytes in brain tissue differs according to mouse age and brain region used for cell isolation.
Protocol
Isolation and cultivation of ACSA-2−positive astrocytes from neonatal mouse brain
45 min
Dissociation of brain tissue
1 h
Isolation of astrocytes
30 min
Flow cytometric analysis
7 d
Cell culture
1 h
Immunocytochemical staining of cultured cells
Adjust cell culture time to meet experimental objectives.
This protocol includes detailed instructions for preparing necessary reagents and materials and then carrying out each step.
PB buffer: Prepare a solution containing phosphate-buffered saline (PBS), pH 7.2, and 0.5% bovine serum albumin (BSA) by diluting MACS® BSA Stock Solution 1:20 with PBS. Keep buffer cold (+2 to +8 °C). Prepare fresh on the day of use and degas the buffer, as air bubbles could block the column.
▲ Note: BSA can be replaced by other proteins such as mouse serum albumin, mouse serum, or fetal bovine serum (FBS).
Preparation of AstroMACS Medium and cell culture dish
- Thaw MACS NeuroBrew®-21 at +2 to +8 °C prior to use.
- Reconstitute lyophilized AstroMACS Supplement with 1 mL MACS Neuro Medium.
▲ Note: Single-use aliquots of the reconstituted AstroMACS Supplement can be stored at –20 °C. It is recommended to prepare aliquots of 100 μL. - Add 0.2% of the reconstituted AstroMACS Supplement, 2% of the MACS NeuroBrew-21, 50×, and 0.25% L-glutamine (0.5 mM) to the MACS Neuro Medium, e.g., add 100 μL AstroMACS Supplement, 1 mL MACS NeuroBrew-21, and 125 μL L-glutamine to 50 mL MACS Neuro Medium.
▲ Note: Use the complete medium within two weeks when stored at +2 to +8 °C. Do not freeze. - Coat the culture dish (24-well plate) with 0.01% Poly-L-lysine overnight at +37 °C. Wash three times with ddH2O. Let the culture dish dry under sterile conditions.
Good to know
The data sheet for the Neural Tissue Dissociation Kits includes a set of tips & hints to improve the quality and yield of the dissociation procedure. Refer to the data sheet appendix if, for example, the yield of viable cells is too low or a cell pellet will not form.
Use the Neural Tissue Dissociation Kit (P) or Neural Tissue Dissociation Kit (T) to dissociate brain tissue and prepare a single-cell suspension. Follow the protocol of the kit data sheet.
Download data sheet
Isolate the ACSA-2−positive astrocytes from the single-cell suspension using the Anti-ACSA-2 MicroBead Kit, mouse. Follow the protocol of the kit data sheet.
Download data sheet
- The recommended antibody dilution for labeling cells is 1:10 for up to 1×106 cells/50 μL of PB buffer.
- Volumes given below are for up to 1×106 nucleated cells. When working with fewer than 1×106 cells, use the same volumes as indicated. When working with higher cell numbers, scale up all reagent volumes and total volumes accordingly (e.g. for 2×106 nucleated cells, use twice the volume of all indicated reagent volumes and total volumes).
- Use 100 μL of the ACSA-2+ fraction for analysis. Optionally, also analyze 100 μL of the negative fraction and 20 μL of the original fraction.
- Resuspend up to 1×106 nucleated cells per 45 μL of PB buffer (see "Things to prepare in advance of cell isolation and cell culture").
▲ Note: Always use freshly prepared buffer. - Add 5 μL of ACSA-2 Antibody, anti-mouse, APC.
- Mix well and incubate for 10 minutes in the refrigerator (+2 to +8 °C) in the dark.
▲ Note: Higher temperatures and/or longer incubation times may lead to non-specific cell labeling. Working on ice requires increased incubation times. - Wash cells by adding 1 mL of PB buffer and centrifuge at 300×g for 10 minutes. Aspirate supernatant completely.
- Resuspend cell pellet in a suitable amount of PB buffer for analysis by flow cytometry, e.g., using the MACSQuant® Analyzer 10.
- Plate 1×105 cells in 50 μL pre-warmed prepared AstroMACS Medium as a drop in the middle of each well of a coated 24-well plate (see "Things to prepare in advance of cell isolation and cell culture")
- Carefully add 450 μL of prepared AstroMACS Medium to each well.
▲ Note: Cells loosely attach after the first days of cultivation. Therefore, a cultivation period of approximately one week is recommended.
Things to prepare in advance
Staining buffer: Prepare a solution containing autoMACS® Running Buffer with FcR Blocking Reagent, mouse in a ratio of 1:10, e.g., add 1 mL FcR Blocking Reagent to 9 mL autoMACS Running Buffer.
- Wash cells 3× with PBS.
- Fix cells with 2% PFA for 10 minutes at room temperature.
- Wash cells 3× with PBS.
▲ Note: Fixed cells can be stored in azide-containing buffer at +2 to +8 °C for up to one week. - Add staining buffer (see "Things to prepare in advance") and incubate for 10 minutes at room temperature.
- Discard staining buffer.
- Add primary antibody in staining buffer to the cells with a final concentration of 1–5 μg/mL and incubate at room temperature in the dark for 10 minutes.
- Wash cells 3× with autoMACS Running Buffer.
- Add a corresponding secondary antibody in staining buffer to the cells and incubate at room temperature in the dark for 10 minutes.
- Wash cells 3× with autoMACS Running Buffer.
▲ Note: For co-staining with additional antibodies repeat steps 6–9. - Store cells in autoMACS Running Buffer.
- Cells are now ready for immunofluorescence microscopy.
▲ Note: Samples can be stored at +2 to +8 °C in the dark for up to one week
▲ Note: When working with cells cultured on coverslips, the coverslips need to be mounted onto slides before imaging.
18 products found
|
For research use only
500 mL
(excl. tax)
For research use only
177,00 EUR
(excl. tax)
For research use only
573,00 EUR
(excl. tax)
For research use only
For research use only
FC
100 µg in 1 mL
(excl. tax)
For research use only
1 mL
(excl. tax)
For research use only
For research use only
50 filters
(excl. tax)
For research use only
(excl. tax)
For research use only
845,00 EUR
(excl. tax)
For research use only
For research use only
6× 1.5 L
(excl. tax)
For research use only
For research use only
50 filters (sterile, single-packed)
(excl. tax)
For research use only
For research use only
FC
100 µg in 1 mL
(excl. tax)
For research use only
125,00 EUR
(excl. tax)
For research use only
For research use only
20 pieces
(excl. tax)
For research use only
6× 75 mL
(excl. tax)
For research use only
2 mL
(excl. tax)
For research use only
For research use only
1 unit
For research use only
For research use only
for 5×107 total cells
(excl. tax)
You have previously chosen International as your location.
What do you want to do?